Conveyor Systems
Motorized Drive Roller (MDR) technology is the most revolutionary since the advent of the line-shaft conveyor in the late ’60s. Its impact is currently expanding rapidly as more users and manufacturers begin to see the benefits of this technology.
Operator Friendly
Increased safety
Low torque verses conventional motors
No sprockets or chains reduce pinch points
Photo sensors in side frame reduce catch points
Low noise improves working environment
Powder coat conductive paint reduces sharp edges
Operations Friendly
Reliable – failures typically effect only a single zone
Flexible – built-in variable speed, accel and decel
Modular – easy reconfiguration
Clean – no grease or oil
True zero-pressure accumulation
Low energy use – 50-75% less than other systems
Low over-all cost of ownership
Maintenance Friendly
Fewer spare parts
Low cost spare parts
Short repair times
Consistent operation and repair across modules
24 volt DC typically doesn’t require an electrician
Most repairs can be done by a single person
Staff typically can carry parts with them
MDR Controls
A typical MDR system uses rollers that include 24VDC brushless and 24 Volt Gearless motors. This roller is connected to slaved rollers with urethane belts. Photo-eyes are used to detect product, and provide accumulation control.
When considering MDR applications, several design criteria must be established to provide a system that will meet short and long term needs. The first consideration should be power distribution. Unlike a typical conveyor installation, where 480VAC is delivered to widely distributed AC motors, Hilmot MDR applications require 24VDC with relatively high current capacity at every conveyor section.
A typical 10′ bed with 30″ zones will require 4 motorized rollers, each demanding about 3 amps at 24VDC, so we typically provide 12 amps capacity per 10 foot of conveyor. To deliver this power, we factory locate and wire (1) power supply per 30 zones. Installation time and cost are significantly reduced, as once the beds are installed.